The hot summer is not only a summer sun for people, but also a difficult season for cars. In summer, if you do not pay attention to maintenance, the car will not only produce a variety of odors, but also cause safety problems. Therefore, in the summer or in time pay attention to the maintenance of the car. With the advent of high-temperature weather, many reports have reported high-temperature car-induced hyperthermia. So how do you take care of summer car maintenance?
We all know that the hot summer is the season of high burst of automobile tires. Due to high temperatures, poor quality tires or high tire pressure, tire inflation can cause tire bursts. Therefore, at this time, the owner should pay attention to the maintenance of the tire. If any damage is found, it should be promptly repaired or replaced. We all know that the consumption of glass water in the summer is quite amazing, so the glass water should be changed regularly in summer. Because in the summer, in addition to normal use, there are many parts that evaporate at high temperatures, so check the glass water regularly. If you find it cumbersome or inconvenient, you can have a car maintenance professional perform maintenance.
Air conditioning should also be used rationally. In the summer, when entering the compartment, do not worry about turning on the air conditioner. You should open the window to ventilate the air, open the outer circulation, wait until the hot air in the vehicle is removed and then turn on the air conditioner. This way, the cooling effect is easy to achieve. If there is an odor inside the air-conditioner, it may be that the air-conditioner has built up bacteria inside. At this time, the air-conditioner must be completely cleaned. As the temperature rises, the amount of oil and water to be increased will also increase. Therefore, check whether the fuel tank of the vehicle is covered tightly and pay attention to whether the oil pipe is leaking.
In addition, the high temperature is very easy to make the brake oil heat expansion and brake effect is greatly reduced. In addition, the frequent braking and sand-filled environments have severely worn the brake pads. If the wear exceeds the factory floor mark or abnormal sound occurs when the brakes are applied, it means that the brake pads must also be checked and replaced. Summer driving and maintenance should be done well so that your car will run smoothly and comfortably.
Wheelhouse Panel Injection Mould
Wheelhousing/Fender is installed in the wheel frame behind the plate structure, usually made of high-quality rubber material, but also the use of engineering plastic fender is usually installed in the bicycle or motor vehicle wheels behind a metal baffle, cofskin baffle, plastic baffle, rubber baffle.
Professional Car Part Mould,Professional Auto Part Mould,Auto Parts L Plastic Injection Molding,Car Small Injection Mould
Taizhou Huangyan Xingtai Plastic Mould Co., Ltd. , https://www.xingtaimould.com