2. The operator must understand the structure and performance of the classifier.
3. In order to prevent the steel ball from the larger material or the mill from falling into the classifier during operation, the chip is installed at the inlet of the classifier and the chip is installed on the overflow port.
4. When stopping the work, the feeding should be stopped first, so that the spiral removes the material in the tank; when the work stops suddenly, the spiral should be raised to avoid fouling.
5. When lifting the spiral, the blade has left the liquid surface, and the spiral lifting should be stopped immediately. When the spiral blade contacts the water surface when descending, the spiral can be rotated. When the spiral is raised to the highest position, it should be suspended by wire rope to avoid long-term load of the wire cylinder. And deformation.
6, the speed of the decline, depending on the size of the current, generally ≤ 16A, and the drum feeder can not have a phenomenon of spitting.
7. When the spiral rotation has entered normal operation, when the slurry enters the water tank for classification, the groove surface of the lower support and the water tank is not allowed to leave.
8. The end point of the lifting mechanism is the terminal of the screw. The operator must pay attention to the lifting height to avoid accidents caused by the screw.
9, working hours must pay attention to the various lubrication parts, timely oil injection, to ensure the good operation of the gear rotating parts.
10. In order to ensure the normal operation of the classifier, there should be scheduled regular maintenance.
Titanium Forging,Medical Forging Titanium,Pure Titanium Forging,Astm Titanium Forging
TMT INDUSTRY , https://www.tmtmedtech.com